Ecto Goggles Parts, Diagrams & Instructions
This page provides guidance for the Ecto Goggles Kit. Here you will find the list of parts, diagrams for assembly, and links to the various goggle shells.
Parts list for Ecto Goggles Kit
This is a list of parts included in the Ecto Goggles kit. These are replacement parts if you want to buy the parts individually or you need to repair something. Otherwise, please purchase the unassembled kit.
- EG01 – Main Control Board (GB Fans, Goon, Spirit)
- EG02 – DY-SV17F Soundboard with Audio Files
- EG03 – MPU-6050 Accelerometer
- EG04 – 2 Long Lead 3mm Green LEDs
- EG05 – 1 Red LED 5mm & 1 Green LED 5mm
- EG06 – Long Stem Switch – 3 pin – 6mm
- EG07 – Right Angle Male USB-C PCB Connector
- EG08 – 9 Right Angle 2 pin 1.25 Female Connectors
- EG09 – 1 Straight 2 pin 1.25 Female Connector
- EG10 – T-Display-S3 ESP32-S3 1.9 inch with Code & 1.25mm Male Wire
- EG11 – Batteries – 3.7v 100mAh
- EG12 – Speaker 20mm
- EG13 – Charging Cable
The Goon 3d Model from Thingiverse
This is one of the best 3d models out there. It has fantastic detail and all of the parts to complete it.
You can download the files to print it here.
GB Fans Shell
Quite possibly the best reproduction Ecto Goggles frames out there. These are
based on a set of real AN/PVS-5 Night Vision Goggle frames.
You can order these here.
You can also 3D print these goggles by MakerGulbi which are very similar to the GB Fans shell.
The GB Fans electronics kit will fit these goggles. You may want to reduce the print size by a few percentage points.
Assembly & Component Diagram